3rd Wave OS version 1.0n

bug fixes since version 1.0:
 - fix for midi program change via midi din
 - fix for mod source and destination button hold
 - fix for elusive stuck notes
 - fix for tempo drifts in sequencer and arp
 - fixes for midi clock sync + song position pointer
 - improvements to volume potentiometer to have smooth fade out
 - improvements to analog waveforms on low notes
 - part clear in sequencer
 - envelope repeat
 - improvements to velocity precision for 3rd Wave keyboard - velocity curve still needs work
 - improvements to sawtooth analog model
 - improvements to potentiometer precision
 - synthplex update: slightly wider dead zone for detent pots + fix for usb drive not mounting on latest Mac OS on certain hubs
 - unison + arp settings now editable per part
 - global setting MIDI multitimbral mode to control parts on separate MIDI channels
 - reverse mode for osc key to waves setting, to replicate ppg behavior
 - improvements to Circuit Drift: envs, filters, fine tuning follow a set of repeatable changes + other suggestions
 - fixes for multitimbral playback in sequencer
 - fix to spatial panning wraparound to always get movement
 - fix for arp start with midi sync
 - fix for setting mod destinations per part
 - fix for note hang when disconnecting sustain pedal in certain configs
 - fix for midi active sensing message, Yamaha Montage issue
 * fix for issue in analog waveforms recently introduced, especially in A04, supersaw waveform
 * fix for envelope sustain modulation
 * fixes for curcuit drift, analog filter cutoff and resonance per part
 
TO LOAD A NEW OS:
1. Connect your 3rd Wave to your computer, (Windows or Mac), via the USB connector on the back of the Synth.
2. Once connected the 3rd Wave will show up as an external drive
3. Copy the "ldr" file into the firmware folder on the 3rd Wave.
4. Once the copy is finished, press the global key on the 3rd Wave and then the left most encoder knob above the display to go to the "Firmware Update" selection
5. Use the second encoder from the left to select "Go"
6. The screen will now show "Firmware file: N/A", it will load the filename after a slight pause or press the refresh button at the bottom of the screen.
7. The display will now show the name of the file that you placed in the firmware folder.
8. Press "OK" at the bottom right.
9. The display will tell you when it is finished updating.
10. Once the display indicates that it is finished, disconnect the USB cable from the synth, re-boot the synthesizer.